NivaarExam Prep

04-BS-4

Worked solutions to 13 past sittings (2013–2018), 91 questions. Pick a sitting, or start from a topic below.

Topics across the sittings

Topics that come up in more than one sitting, taken from the headings of our worked solutions. A topic counts once per sitting.

Questions by sitting

December 2018

  1. Question 1: DC Network -- KCL, KVL, Power, and a Current Source Solved from an Observed Voltage
  2. Question 2: Thevenin Equivalent and Maximum Power Transfer
  3. Question 3: First-Order RL Transient -- Switch Opening
  4. Question 4: Parallel RLC Network -- Power and Series Resonance
  5. Question 5: Power-Factor-Correction Capacitor Switched Across an Inductive Load
  6. Question 6: Full-Wave Bridge Rectifier and RC Ripple Filter
  7. Question 7: Magnetic Circuit -- Horseshoe Core, Air Gap, and Relay Armature

May 2018

  1. Question 1: DC Bridge Network — KCL/KVL, Power in R1, Power of Vs3
  2. Question 2: Thévenin Equivalent and Maximum Power Transfer
  3. Question 3: First-Order RL Transient — Steady State, Stored Energy, Time Constant, Response Plot
  4. Question 4: AC Steady-State Phasor Analysis — Series-Fed Parallel Resonant Load
  5. Question 5: Magnetic Circuit — Horseshoe Core with Armature and Air Gap
  6. Question 6: Full-Wave Bridge Rectifier Design
  7. Question 7: Combinational Logic — Two-Floor Elevator Control

December 2017

  1. Question 1: DC Bridge Network — KCL/KVL, Vab, Power in R4
  2. Question 2: Thévenin Equivalent and Maximum Power Transfer
  3. Question 3: AC Steady-State — Power, Branch Currents and Resonance
  4. Question 4: Switched Two-Source AC Loop
  5. Question 5: Magnetic Circuit — MMF, Reluctance and Air-Gap Flux
  6. Question 6: Full-Wave Rectifier and RC Low-Pass Filter Design
  7. Question 7: Two-Floor Elevator Control Logic

May 2017

  1. Question 1: DC Bridge Network — Kirchhoff's Laws and an Unknown Branch Resistance
  2. Question 2: Thévenin Equivalent and Maximum Power Transfer
  3. Question 3: Switched RL Network — Steady State, Stored Energy, and Transient Decay
  4. Question 4: AC Steady-State Phasor Analysis with a Resonant Tank
  5. Question 5: Magnetic Circuit — Horseshoe Core with Air Gap and Armature
  6. Question 6: Full-Bridge Rectifier and RC Low-Pass Filter
  7. Question 7: Combinational Logic Design — Subway Door Control

December 2016

  1. Question 1
  2. Question 2
  3. Question 3
  4. Question 4
  5. Question 5
  6. Question 6
  7. Question 7

May 2016

  1. Question 1: DC Bridge Network — KCL/KVL and an Unknown Source Current
  2. Question 2: Thevenin Equivalent and Maximum Power Transfer
  3. Question 3: Switched RC Network — Time Constants and Stored Energy
  4. Question 4: AC Steady-State Phasor Analysis
  5. Question 5: Magnetic Circuit — Horseshoe Core with Air Gap and Armature
  6. Question 6: Full-Bridge Rectifier and RC Low-Pass Filter
  7. Question 7: Combinational Logic Design — Subway Door Control

December 2015

  1. Question 1: DC Circuit — KCL, KVL, and Branch Quantities
  2. Question 2: Thévenin Equivalent and Maximum Power Transfer
  3. Question 3: First-Order RL Transient
  4. Question 4: AC Steady-State Phasor Analysis
  5. Question 5: Magnetic Circuit — Reluctance and Air-Gap Flux
  6. Question 6: Full-Wave Center-Tapped Rectifier and RC Filter Design
  7. Question 7: Combinational Logic Design — HVAC Controller

May 2015

  1. Question 1: DC Bridge Network — KCL, KVL, and the Unknown Source Current
  2. Question 2: Thévenin Equivalent and Maximum Power Transfer
  3. Question 3: First-Order RL Switching Transient
  4. Question 4: AC Steady-State — Power and Resonance
  5. Question 5: AC Power Flow with a Switched Power-Factor Capacitor
  6. Question 6: Full-Wave Bridge Rectifier and DC-Side Filter
  7. Question 7: Combinational Logic Design — Vehicle Alarm and Control

December 2014

  1. Question 1: DC Circuit – KCL/KVL and an Unknown Resistor
  2. Question 2: Thevenin Equivalent and Maximum Power Transfer
  3. Question 3: Switched RLC Circuit – Resonance and AC Power
  4. Question 4: AC Steady-State Phasors, Two Sources
  5. Question 5: Magnetic Circuit – Reluctance, Flux, and Inductance
  6. Question 6: Half-Wave Rectifier and RC Filter Design
  7. Question 7: Combinational Logic Design – Elevator Control

May 2014

  1. Question 1: DC Bridge Network — KCL/KVL, V ab and Power in R 4
  2. Question 2: Thévenin Equivalent and Maximum Power Transfer
  3. Question 3: AC Steady State — Series and Parallel Resonance
  4. Question 4: Two-Source AC Phasor Network
  5. Question 5: Magnetic Circuit — Relay Armature
  6. Question 6: Full-Wave Bridge Rectifier Design
  7. Question 7: HVAC Combinational Logic Design

December 2013

  1. Question 1: DC Ladder Network — KCL, KVL and Source Current
  2. Question 2: Thévenin Equivalent and Maximum Power Transfer
  3. Question 3: AC Steady-State Phasor Analysis
  4. Question 4: Switched-Capacitor First-Order Transient
  5. Question 5: Magnetic Circuit with an Air Gap
  6. Question 6: Half-Wave Rectifier and RC Smoothing Filter (Problem 6)
  7. Question 7: Combinational Logic for a Two-Level Lift

May 2013

  1. Question 1: DC Bridge Network — KCL, KVL and Solving for an Unknown Resistor
  2. Question 2: Thévenin Equivalent and Maximum Power Transfer
  3. Question 3: First-Order RL Transient Following a Switch Opening
  4. Question 4: AC Steady-State Phasor Analysis with Two Sources
  5. Question 5: AC Power Flow on a Line-Load System, With and Without a Shunt Capacitor
  6. Question 6: Full-Wave Bridge Rectifier Design
  7. Question 7: Magnetic Core with an Air Gap

Undated paper

  1. Question 1: DC Resistive Network — KCL, KVL, Branch Current and Source Power
  2. Question 2: Thévenin Equivalent and Maximum Power Transfer
  3. Question 3: First-Order RC Switching Transient
  4. Question 4: Sinusoidal Steady State — Phasors and Capacitor Current
  5. Question 5: Magnetic Circuit — Reluctance, MMF, Flux Density and Armature Force
  6. Question 6: Full-Wave Bridge Rectifier and RC Low-Pass Filter Design
  7. Question 7: Combinational Logic Design — Wind Turbine Pitch Controller